Humboldt State University ® Department of Chemistry

Robert A. Paselk Scientific Instrument Museum

 
From: A. Wilmer Duff. A Text-Book of Physics 5th ed. P. Blakiston's Son & Co. Philadelphia (1921) pp. 207-208.
 
Copyright © 1998 Richard A. Paselk
 

 
 
266. Mercury Thermometers.--For ordinary purposes thermometers depending on the expansion of mercury confined in a bulb and tube of glass or other transparent substance are most convenient and universally used. Two standard forms are shown in Fig. 173, the mercury being confined in a thin-walled glass bulb attached to an extremely fine capillary tube. For use at ordinary temperatures the upper part of the capillary contains only mercury vapor. Since mercury expands somewhat less than 1/5000 part of its volume at 0°C. for a degree rise in temperature (compare with air above), it is necessary to have a very fine capillary in order to obtain an easily observable motion of the column for a degree change in temperature. All such thermometers should, for precise work, be calibrated or standardized by comparison with the hydrogen standard.
 
Fig. 173 shows the two standard ways of marking the "scale" on the thermometer. In one the scale is marked directly on the stem of the thermometer- this is the most accurate and permanent way used in all standard scientific thermometers and clinical thermometers: in the other the scale is on paper or white glass and enclosed in an outer glass tube back of the capillary stem- this usually gives more legible scales but they are somewhat likely to become loose and shift with respect to the capillary. A third method is used for cheap "household" thermometers: in this the thermometer is simply mounted on a support which carries the scale.
 
The glass used for the thermometer (especially the bulb) is of the greatest importance, and in recent years great improvements have been made in the qualities of glass used for this purpose. A bulb made of ordinary glass has the fault of slowly changing its volume with time, and of permanently and quickly increasing its volume whenever it is heated; say to 100°C. or higher. Such changes, of course, alter the reading for a given temperature. Some of these effects gradually disappear after the bulb has been made, so that thermometer bulbs should be kept for some time, or else artificially "aged" by heating and cooling, before being graduated.
 
Through the development of special glasses having high melting-points it has become possible to construct mercury-in-glass thermometers reading to 550°C. or even higher. In such high-range thermometers the space above the mercury column must be filled with a gas (usually carbon dioxide or nitrogen) at a final pressure of about 19 atmospheres, in order to keep the mercury from boiling. For such thermometers the properties of the glass are of the greatest importance, and the glass known as "Jena 59III" is the best one to use. Even with this glass if the thermometer is kept at 550°C. for an hour or more a permanent expansion of the bulb will result; this will permanently lower the freezing-point reading, but if this change is applied as a correction (added) to subsequent readings of the thermometer, fairly correct results can be obtained. Thermometers of mercury in clear fused quartz have also recently been satisfactorily constructed for use up to about 700°C.
 
In using thermometers it is well always to avoid too sudden heating or cooling; and in measurements above 100° (or in all cases where extreme accuracy is required) it must be remembered that thermometers are usually graduated to read correctly when bulb and stem are all at the temperature to be measured. If the stem is cooler than the bulb the thermometer will read too low and this error may amount to as much as 40° at 550°C. In careful work thermometers should always be compared with a standard or standardized at known temperatures or sent to the Bureau of Standards for comparison.
 

 

Index of Instruments

Museum Home

Instrument Literature

 

 
HSTC (1921-34)
HSC (1935-1953)
HSC (1954-1973)
© R. Paselk
Last modified 22 July 2000